Removing And Attaching The Usb Wireless Lan Unit - NEC P350W User Manual

Removing and attaching the USB Wireless LAN Unit

NOTE:
• The USB Wireless LAN Unit must be inserted into the USB Wireless LAN Unit port in the correct direction. It cannot be inserted
in the reverse direction. If the USB Wireless LAN Unit is inserted in the reverse direction with excessive force applied, the USB
port may break.
• Before touching the USB Wireless LAN Unit, touch a metallic object (such as a door knob or aluminum window frame) to discharge
the static electricity from your body.
• Always insert or remove the USB Wireless LAN unit when the main power is turned off. Failure to do so may cause projector
malfunction or damage to the USB wireless LAN unit. If the projector will not work correctly, turn off the projector, disconnect
the power cord, and then connect it again.
• Do not insert other USB devices into the USB Wireless LAN unit port. Do not insert the USB Wireless LAN unit into the USB (PC)
port (Type B).
Prepare a Phillips screw driver beforehand.
1. Press the POWER button to turn off the projector and set it
into standby condition, and disconnect the power cord.
2. Remove the USB (LAN) port cover.
Loosen the screw securing the port cover.
• The screw is not removable.
3. Slowly pull out the USB Wireless LAN Unit into the USB (LAN)
port.
Keep the cap for later use.
4. Put the USB (LAN) port cover back into place.
Insert the catch of the USB (LAN) port cover into the groove of the
projector cabinet, and then tighten the screw to secure the port
cover.
To install the USB Wireless LAN Unit, disconnect the power cord and
use the above procedure.
NOTE:
• The green LED on the USB Wireless LAN Unit flashes to show that Wireless
LAN Unit is working. If the USB Wireless LAN Unit is incorrectly attached,
the blue LED will not flash.
• Do not press the button on the USB Wireless LAN Unit. The button will not
work with this model.
6. Installation and Connections
141
2
1