LG LW8012ERJ Owner's Manual
LG LW8012ERJ Owner's Manual

LG LW8012ERJ Owner's Manual

8,000 btu window air conditioner with remote
Hide thumbs Also See for LW8012ERJ:

Advertisement

Advertisement

Table of Contents
loading

Summary of Contents for LG LW8012ERJ

  • Page 2 Before Operation...
  • Page 8 NOTE: Your air conditioner may differ from the one shown.
  • Page 11: Location Requirements

    Parts supplied: Check that all parts are included in parts package. A. Top channel B. Foam seal C. Side brackets (2) D.Window lock bracket ” screws (3) ” screws (9) G. Side curtains (2) H.Side curtain frames (2) I. Remote control Gather the required tools and parts before starting installation.
  • Page 12: Unpack The Air Conditioner

    Window Installation Window opening measurements: MODEL A. Width 8000 BTU Dimension B. Height A(inch) Min 25”(63.5cm) A(inch) Max 36”(91.4cm) B(inch) Min 13 ”(34cm) Unpack the Air Conditioner Remove Packaging Materials NOTE:The air conditioner must set upright for one hour before operating. Remove and dispose of/recycle packaging materials.
  • Page 13 Slide the side curtain frame into the top Install Side Curtains channel on the top of the air conditioner and the track on the bottom of the air conditioner. NOTE: Attach curtains to the air conditioner before placing the air conditioner in window. Place the tabbed side of the side curtain in the track on the right-hand side of the air conditioner cabinet.
  • Page 14: Positioning The Air Conditioner

    Positioning the Air Conditioner NOTES: Handle the air conditioner gently. Be sure your air conditioner does not fall out of the opening during installation or removal. Slide the side bracket over the screw. The place where the power cord exits the air Tighten the screw.
  • Page 15: Completing The Installation

    ” Use a drill bit to drill a starter hole through Attach Side Curtains to Window the bottom hole in the side curtain and into the window frame. ” Insert one of the screws through the channel. bottom hole of the left-hand curtain and into ”...
  • Page 16 POWER Operation starts when this button is pressed and stops when you press the button again. FAN SPEED SELECTOR For increased power while cooling,select a higher fan speed. 3 steps:High Low. ON/OFF TIMER Please refer to page 18 in details OPERATION MODE SELECTOR a.
  • Page 17: Temperature Control

    TEMPERATURE CONTROL Press the TEMP/TIME up arrow button to raise the temperature. Each time you press or hold the TEMP/TIME uparrow button, the temperature will go up 1ºF until it reaches 86°F (30°C). Press the TEMP/TIME down arrow button to lower the temperature. Each time you press or hold the TEMP/TIME down arrow button, the temperature will go down 1ºF until it reaches 61°F (16°C).
  • Page 18 Timer To set the Timer for a 1-hour to 24-hour delay before the air conditioner is turned off (the air conditioner must be On): 1. Press TIMER. T be on/off. 2. Press the TEMP/TIME up or down arrow button to change the delay time from 1 hour to 24 hours.
  • Page 19 A. 4-Way Air Flow NormalSounds When your air conditioner is operating normally, you may hear sounds such as: Droplets of water hitting the condenser, causing a pinging or clicking sound. The water droplets help cool the condenser. Air movement from the fan. Clicks from the thermostat cycle.
  • Page 20: Cleaning The Air Filter

    Your new air conditioner is designed to give you many years of dependable service. This section tells you how to clean and care for your air conditioner properly. CleaningtheAirFilter filter helps remove dust, lint, and other particles from the air and is important for best cooling and operating efficiency.Check the filter every 2 weeks to see whether it needs cleaning.

Table of Contents