Table of Contents
Advertisement
Available languages
Available languages
NMEA 2000 Transducer Adapter Kit
Use the Garmin
NMEA 2000 Transducer Adapter Kit to adapt depth information, which is
®
currently provided by an installed Airmar
boat, to your NMEA 2000
you to observe depth information on compatible Garmin display devices connected to your
NMEA 2000
network. For a list of compatible Garmin devices, visit www.garmin.com.
®
Contact Garmin
Contact Garmin Product Support if you have any questions while installing your NMEA 2000
Transducer Adapter Kit. In the USA, go to www.garmin.com/support, or contact Garmin USA
by phone at (913) 397.8200 or (800) 800.1020. In the UK, contact Garmin (Europe) Ltd. by
phone at 0808 2380000. In Europe, go to
for in-country support information, or contact Garmin (Europe) Ltd. by phone at +44 (0)
870.8501241.
See the Important Safety and Product Information guide in the compatible Garmin display
device box for product warnings and other important information.
Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
When drilling or cutting, always check the opposite side of the drilling or cutting surface.
Needed Tools and Supplies
•
A drill and a
/
3
32
•
A number 2 Phillips screwdriver
•
Wire cutters
Determining an installation Location
When you are selecting a location at which to install the NMEA 2000 Transducer Adapter, refer
to the layout diagram on
•
Install the adapter at least 37
•
If possible, install the adapter close to the location you disconnect the installed transducer
from the installed head unit, most likely behind the dashboard.
•
The adapter is IEC 60529 IPX7 waterproof, and can be submerged up to 30 minutes at
1 meter. Do not install the adapter in a location where it will be submerged consistently,
although the location can be subject to wash-down.
•
Verify that all cables will reach the location before beginning the installation procedures.
Installation Instructions
network. The Garmin NMEA 2000 Transducer Adapter Kit allows
®
in. (2.5 mm) drill bit
page 4
and consider the following:
/
in. (95 cm) from a compass to avoid interference.
1
2
P19 (or compatible) 200 kHz transducer on your
®
www.garmin.com/support
WArNiNG
CAuTioN
notice
•
Pliers
•
Cable ties
•
Additional NMEA 2000 cabling and
connectors (optional)
Contact Support
and click
Advertisement
Table of Contents
