Installing The Adapter - Dynex DX-ECFW User Manual

Firewire 800 expresscard adapter user guide
Hide thumbs Also See for DX-ECFW:
Table of Contents

Advertisement

Installing the adapter

not require the optional power adapter to be connected in
order to work. However non-powered FireWire devices require
an optional 12V/2A power adapter to work.
Installing the adapter
To install the FireWire ExpressCard adapter:
• Carefully insert the adapter into the ExpressCard slot of
your laptop until it's firmly seated in the ExpressCard slot.
(Refer to the ExpressCard slot instructions from your
laptop's user guide).
Windows installation:
Windows 2000, Windows XP, and Windows Vista automatically detect the
adapter after it is installed, then installs the correct driver. No separate
driver installation is needed.
To verify proper installation in Windows:
1 To verify if the device exists in your computer and is
enabled, right-click My Computer, then select
Properties.
2 Click Device Manager and open the entry IEEE 1394 Bus
host controllers.
If the device has been properly installed, its sub-entry
should be displayed as OHCI Compliant IEEE 1394 Host
Controller in Windows 2000 and Windows XP or AGERE
OHCI Compliant IEEE 1394 Host Controller in
Windows Vista.
Mac OS X (v10.4 or later) installation:
Computers with Mac OS X v10.4 or later include a FireWire driver provided
by the operating system. No additional driver software is necessary. After
the FireWire ExpressCard adapter is installed, start the computer.
: FireWire devices have their own power supply and do
5

Advertisement

Table of Contents
loading

Table of Contents