Table of Contents
Advertisement
Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Temperature cannot
be set .
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is too
high.
Upper or lower
square is shown in
the temperature dis-
play.
DEMO appears on
the Display.
REPLACING THE LAMP
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the light-
ing device. Contact your Service Center .
CLOSING THE DOOR
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
"Installation".
3.
If necessary, replace the defective door
gaskets. Contact the Service Center.
Possible cause
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clogged. Clean the water outlet.
Products prevent that wa-
ter flows into the water col-
lector.
Shopping function switch-
ed on.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
An error has occurred in
measuring the tempera-
ture.
The appliance is in demon-
stration mode (DEMO).
ENGLISH
Solution
This is correct.
Make sure that products do
not touch the rear plate.
Switch off Shopping man-
ually, or wait to set the tem-
perature until the function
has reset automatically. Re-
fer to ShoppingMode .
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Call your service representa-
tive (the cooling system will
continue to keep food prod-
ucts cold, but temperature
adjustment will not be possi-
ble).
Keep pressed approximately
10 sec. the Mode button
since a long sound of buzzer
is heard and the Display
shut off for a short while: ap-
pliance start works regular-
ly.
13
Advertisement
Table of Contents
