Information On Laundry; Fine Adjustment Of The Drying Result; Care And Cleaning; Programme Overview - Bosch WTV74309GB Instructions for Use, Programme Table Instruction Manual

Information on laundry ...

Labelling of fabrics
Follow the manufacturer's care information.
Drying at normal temperature.
Drying at low temperature also select
Do not machine dry.
Observe safety instructions without fail
Do not tumble-dry the following fabrics for example:
– Impermeable fabrics (e.g. rubber-coated fabrics).
– Delicate materials (silk or curtains made from synthetic material)
– Dripping wet washing high
– Laundry contaminated with oil.
Drying tips
– To ensure a consistent result, sort the laundry by fabric type and drying programme.
– Always dry very small items (e.g. baby socks) together with large items of laundry (e.g. hand
towel).
– Close zips, hooks and eyelets, and button up covers.
Tie fabric belts, apron strings, etc. together
– Do not over-dry easy-care laundry
Allow laundry to finish drying in the air.
– Do not dry woolens in the dryer, only use to freshen them up
Programme (depending on model).
– Do not iron laundry immediately after drying, fold items up and leave for a while
remaining moisture will then be distributed evenly.
– The drying result depends on the type of water used during washing.
of the drying result Page 6.
– Machine-knitted fabrics (e.g. T-shirts or jerseys) often shrink the first time they are dried
do not use the Extra Dry programme.
– Starched laundry is not always suitable for dryers
adversely affects the drying operation.
– Use the correct dosage of fabric softener as per the manufacturer's instructions when
washing the laundry to be dried.
– Use the timer programme for small loads
Environmental protection / Energy-saving tips
– Before drying, spin the laundry thoroughly in the washing machine
speed the shorter the drying time will be (consumes less energy), also spin easy-care
laundry.
– Put in, but do not exceed, the maximum recommended quantity of laundry

programme overview

Page 7.
– Make sure the room is well ventilated during drying.
– Clean the fluff filter after every drying cycle
– Do not obstruct or seal up the air inlet.
Low Heat.
Page 11!
they may crease.
energy consumption!
risk of creasing!
Page 7, Woollens finish
starch leaves behind a coating that
this improves the drying result.
the higher the spin
Page 4.

Fine adjustment of the drying result

Adjustment of the levels of dryness
Turn to Off
L:00, L:01, L:02, L:03 are shown in sequence
Short signal when changing from L:03 to L:00,
otherwise long signal.

Care and cleaning

Dryer housing, Control panel, Air inlet, Moisture sensors
– Wipe off with a soft, damp cloth.
– Do not use abrasive cleaners or solvents.
– Remove detergent and cleaning agent residue immediately.
the
Exhaust air duct
Fine adjustment
Check the exhaust air duct. Clean the exhaust air duct every six months.
Do not bend the exhaust air duct.
1. Switch off the dryer and allow it to cool down.
2. Disconnect the mains plug.
3. Remove the exhaust air duct.
4. Clean the exhaust air duct.
5. Refit the exhaust air duct
Moisture sensors
The dryer is equipped with stainless steel moisture sensors.
Moisture sensors measure the moisture level of the laundry.
After sustained, repeated operation, a fine layer of limescale may form
on the moisture sensors.
1. Open the door.
2. Clean the moisture sensors using a slightly damp sponge with a rough
surface.
Do not use steel wool or abrasive materials.
5
Low Heat and
1 x to Press and hold Press
turn 5 x to the right the required level is reached
the right
Only when switched off!
Installation instructions for exhaust air duct.
Low Heat until
Turn to Off
6