Table of Contents
Advertisement
Installation
Technical data
– Delivery specification: dryer, instructions for installation and use.
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
– If in doubt, have the appliance connected by an expert.
Setting up the dryer
Take all accessory parts
1.
– The appliance plug must always be accessible.
out of the drum.
The drum must be empty.
– Ensure that the appliance is installed on a clean, level
and solid surface.
– Keep the cooling grille at the front of the dryer
unobstructed.
– Keep the area around the dryer clean.
– Make the dryer level using the threaded feet
and a spirit level.
Do not remove the threaded feet under any
circumstances.
Do not set up the dryer behind a door or sliding
door as this may obstruct or prevent the dryer door
from opening. This will prevent a potentially fatal
Clean and level
danger to children from locking themselves in.
Make sure that the air
inlet remains unobstructed
Mains connection
see safety instructions
Page 11.
2.
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
– The mains voltage and the voltage shown on the rating plate (
Page 9) must correspond.
– The connected load and necessary fuse protection are specified on the rating plate.
Do not operate the dryer if
Frost protection / Transport
there is a danger of frost.
Preparation
1. Select any programme using the programme selector.
Optional accessories
2. Press the
Start/Stop button.
3. Turn the programme selector to Off.
WTZ
1130
WTZ
11310
WTZ
10290
7
8
What to do if ...
Dimensions (DxWxH)
60 x 60 x 85 cm (height adjustable)
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales service.
We will always find an appropriate solution and will avoid unnecessary visits by engineers.
Weight
approximately 36 kg
Trust the expertise of the manufacturer and rest assured that the repair will be carried out by
Max. capacity
8 kg
trained service technicians using original spare parts. The contact details of your local after-
sales service can be found in the enclosed after-sales service directory, or by calling one of
Ambient temperature
5 - 35 °C
these numbers:
Connection voltage
– GB 0844 8928979 (Calls from BT landline will be charged at up to 3 pence per minute.
A call set-up fee of up to 6 pence may apply.)
Connected load
– IE 01450 2655
Fuse protection
see appliance rating plate
When contacting the after-sales service, please quote the appliance's product number (E no.)
and production number (FD) (see the inside of the door).
Ambient temperature
Set the programme selector to Off and remove the appliance plug from the socket.
Product number/
The
Start/Stop indicator lamp
Production number
does not light up.
The Filter/Venting Hose
You can find the rating plate on the back of the dryer.
and
Start/Stop indicator lights
Consumption rates
These are guide values determined under standard
are flashing.
conditions. Fluctuations up to 10% are possible.
Dryer does not start.
Spin speed in rpm
Drying time
Energy
(residual moisture)
in min.**
consumption
in kWh**
The door opens by itself and/or
Cottons 8 kg
13 A
13 A
the Door indicator light is lit.
Programme terminated shortly
Cupboard Dry*
1400 (approx. 50 %)
95
3.50
after starting.
1000 (approx. 60 %)
118
4.20
Water is running out.
800
(approx. 70 %)
135
4.79
Creasing.
Iron Dry*
1400 (approx. 50 %)
67
2.37
1000 (approx. 60 %)
90
3.15
800
(approx. 70 %)
107
3.84
Drying result is not satisfactory
(laundry feels too damp).
Easy-Care 3.5 kg
Cupboard Dry*
800
(approx. 40 %)
37
1.18
600
(approx. 50 %)
44
1.48
*Test program according to DIN EN 61121.
**The values may differ from the those specified depending on the type of fabric, mixture
of laundry to be dried, residual moisture in the fabric and loading capacity.
Drying time too long.
Drum interior light
(depending on model)
(bulb E14, 25 W)
The drum is illuminated after the door is opened or closed, and also after the programme
is started. It goes out automatically. Replacing the bulb
Page 10.
The humidity in the room
increases significantly.
(order from the after-sales service using the order number)
One or more indicator lights for
Exhaust air set
(depending on model)
programme status are flashing.
The exhaust air is conveyed directly via a hose.
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. This connection set must always be used to secure the dryer to the washing
Mains failure.
machine. With pull-out worktop: WTZ 11300
The interior light is not working
Installation underneath the worktop
(depending on model).
Risk of electric shock!
Instead of the appliance covering plate, you must have a metal cover fitted by an expert.
Condensation in the exhaust air
duct.
9
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
– in rooms inside the house.
dryer...
– to dry fabrics.
The dryer must
– be used for other purposes than those described above.
NEVER...
– be modified in terms of its technology or attributes.
Dangers
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from pockets.
Mains plug plugged in?
Make especially sure that cigarette lighters are removed as they constitute
Programme selected?
an
explosion hazard.
Clean the fluff filter under running water
Page 4
– Do not lean or sit on the door
Exhaust air duct blocked or knicked?
– Open the door with care. Hot steam may escape.
Clean the exhaust air duct
Page 6.
If necessary, clean the insect screen on the exhaust air pipe.
Installation
– Secure loose cables
tripping hazard.
Start/Stop button selected?
– Do not operate the dryer if there is a risk of frost.
Door closed?
– The safety information in the separate installation instructions for the exhaust
Programme set?
air duct must be observed without fail.
Push the door closed until you hear it engage.
Mains
– Connect the dryer according to specifications to an AC earthed socket,
connection
as otherwise it cannot be guaranteed that the appliance is completely safe.
Ambient temperature higher than 5 °C?
– The cable cross-section must be sufficient.
Align dryer horizontally.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
Laundry load exceeded?
Remove articles of clothing immediately after
– Do not use multiple plugs/couplings and/or extension cables.
the end of the programme, hang up and pull into shape.
– Do not hold the appliance plug with wet hands
Unsuitable programme selected
Page 7.
– Never pull the appliance plug out of the socket by its cable.
Warm laundry feels damper than it actually is.
– Do not damage the mains lead
The selected programme does not suit the load. Use another
Operation
– Only load the drum with laundry.
drying programme or, in addition, select the time programme
Page 7.
Check the contents before you switch the dryer on.
Use fine adjustment for the drying result
Page1/2 and 6.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
Fine layer of limescale on the humidity sensors
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
Clean the humidity sensors
Page 6.
cleaning solvent, etc.)
fire/explosion hazard.
Programme termination, e.g. tank full, mains power supply failure,
– Dust (e.g. coal dust, flour) poses a danger: do not use the dryer
door open or maximum drying time reached.
explosion hazard.
Rinse the fluff filters under running water
Page 4.
– Do not put laundry containing foamed material/rubber in the dryer
Insufficient supply of air
ensure that air can circulate.
Air inlet possibly blocked
Clear inlet
Page 8.
material may be destroyed and the dryer may be damaged due to possible
Ambient temperature higher than 35 °C
ventilate the room.
deformation of the foamed material.
Make sure the room is sufficiently ventilated.
– Switch off the dryer once the programme has ended.
Defect
– Do not use the dryer if it is defective or if you suspect it is.
Clean the fluff filter under running water
Page 4.
Repairs must only be carried out by the after-sales service.
Check installation conditions
Page 8.
– Do not use the dryer if the mains cable is defective. To avoid danger, only
Exhaust air duct blocked or knicked?
have the defective mains cable replaced by the after-sales service.
Clean the exhaust air duct
Page 6.
If necessary, clean the insect screen on the exhaust air pipe.
– Always pull the mains plug out of the socket before changing the bulb
Switch off, leave to cool down, switch on again, restart
for the interior light
risk of electric shock.
programme.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Remove laundry from the dryer immediately and spread out.
Disposal
– Dryer: pull out the appliance plug, then cut off the mains cable
This allows the heat to dissipate.
from the appliance.
Pull out the appliance plug, remove the cover cap in the interior
above the door (use Torx 20 screw driver) and replace the bulb.
Dispose of at municipal waste disposal facility.
Close the cover cap.
– Packaging: do not leave children alone with packing parts
Never operate the dryer without a cover cap.
risk of suffocation.
Exhaust air duct too long? Check the maximum exhaust air duct
– All materials are environmentally sound and can be reused.
length. Further information
Installation instructions for exhaust
Dispose of in an environmentally-responsible manner.
air duct.
10
risk of tipping.
risk of electric shock.
risk of electric shock.
Dryer
elastic
en Instruction manual
11
Advertisement
Table of Contents
