Lsi Corporation Mpt Setup Utility (P8B-C/Sas/2L, P8B-C/Sas/4L Only) - Asus P8B-C/4L User Manual

5.4 LSI Corporation MPT Setup Utility
(P8B-C/SAS/2L, P8B-C/SAS/4L only)
The LSI Corporation MPT Setup Utility is an integrated RAID solution that allows
you to create the following RAID sets from SAS hard disk drives supported by the
LSI 2008 controller: RAID 0, RAID 1, RAID 1E, and RAID 10.
• You may use disks of different sizes in one volume; however, the size of the
smallest disk determines the "logical" size of each member disk.
• DO NOT combine Serial ATA and SAS disk drives in one volume.
• The RAID setup screens shown in this section are for reference only and
may not exactly match the items on your screen due to the controller
version difference.
• The adapter name shown on the setup screens differs according to the
installed SAS RAID card.
• Before requesting support from the ASUS Technical Support team, you
have to take note of the MPTFW and MPTBIOS version for the SAS
controller. After entering the SAS configuration utility, you can see below
screen and identify the MPTFW and MPTBIOS version:
MPTFW version: 8.00.00.00-IR
MPTBIOS version: v7.07.00.00 (2010.04.30)
LSI Corp Config Utility
Adapter List
Adapter
SAS 2008
Esc = Exit Menu
Alt+N = Global Properties
ASUS P8B-C series
v7.07.00.00 (2010.04.30)
Global Properties
PCI PCI PCI
BUS Dev Fnc
01 00 00
F1/Shift+1 = Help
-/+ = Alter Boot Order
PCI FW Revision
Slot
00 8.00.00.00-IR
Ins/Del = Alter Boot List
Status Boot
Order
Enabled 0
5-35