HP 2510p - Compaq Business Notebook Setup And Configuration Manual page 12

Recommended Setting
i. Select N.
If network is disabled, then all remote AMT capabilities are disabled and
TCP/IP settings will not be necessary.
This option is a toggle, the next time it is accessed the opposite setting is
prompted.
a. DHCP Disable
Default Setting
Recommended Setting
i. Select N.
For the purpose of this whitepaper, DHCP is enabled.
17) Go into Provisioning Server.
a. Enter Provisioning Server IP
Default Setting
Recommended Setting
b. Enter Port
Default Setting
Recommended Setting
This option is used in Enterprise mode when an Intel AMT Setup and Configuration
(Provisioning) Server is available. It points to the IP address of the S&CS.
If the IP and port is left as the default, the ME will look for "ProvisionServer" on DNS at port
9971.
Some ISV's may require additional settings, such as the SC&S port number and SC&S IP
address. Contact your Management Console ISV for more details.
18) Check Provision Model.
a. Change to Small Business
Default Setting
Recommended Setting
i. Select N.
b. Return to previous menu.
19) For AMT 2.x, go into Set PID and PPS. For AMT 4.x, go to Setup and Configuration => TLS
PSK => Set PID and PPS
Default Setting
Recommended Setting
This option is for Provisioning ID (PID) and Provisioning Passphrase (PPS) entry. PIDs are 8
characters and PPS are 32 characters. There are dashes between every set of four characters
: Network Interface Enabled
: DHCP Enabled
: User Dependent
: 0.0.0.0
: Network Dependent
: 9971
: S&CS Dependent
: Enterprise
: Enterprise
: None
: System Dependent
12