Installation Notes; Limitations And Restrictions - Cisco 3020 - Catalyst Blade Switch Release Note

Installation Notes

Installation Notes
You can assign IP information to your switch by using these methods:
•
•
•
•
New Software Feature
This release supports Web authentication to authenticate a supplicant (client) that does not support
IEEE 802.1x functionality. For more information, see the
page

Limitations and Restrictions

You should review this section before you begin working with the switch. These are known limitations
that will not be fixed, and there is not always a workaround. Some features might not work as
documented, and some features could be affected by recent changes to the switch hardware or software.
This section contains these limitations:
•
•
Cisco IOS Limitations
These limitations apply to switch:
•
•
•
•
•
•
•
•
•
•
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(35)SE and Later
6
The Express Setup program or the HP Onboard Administrator program described in the getting
started guide.
The CLI-based setup program, as described in the hardware installation guide.
The DHCP-based autoconfiguration, as described in the software configuration guide.
Manually assigning an IP address, as described in the software configuration guide.
19.
"Cisco IOS Limitations" section on page 6
"Device Manager Limitations" section on page 10
"Configuration" section on page 7
"Ethernet" section on page 7
"IP" section on page 8
"IP Telephony" section on page 8
"MAC Addressing Multicasting" section on page 8
"MAC Addressing Multicasting" section on page 8
"QoS" section on page 9
"SPAN and RSPAN" section on page 9
"Trunking" section on page 10
"VLAN" section on page 10
"Documentation Updates" section on
OL-8918-03