HP AJ878A - StorageWorks 320 GB Hard Drive Release Note page 9

NOTE:
Firmware revision 36867 is required with driver version 1.2.7. Firmware revision 17350 was
delivered with the previous 1.2.4 software.
9. Once firmware has been upgraded, the user will be prompted to shutdown. Please shutdown.
NOTE:
Changes to IO Accelerator drive firmware will not take effect until a shutdown is complete. One
can re-attach the IO Accelerator drive without rebooting, but new firmware doesn't appear in
the HP IO Manager until a complete power cycle (shutdown) has taken place.
Determining current version
Determining current Linux version
1. From shell prompt, enter the following command to show the current version of the software that
is installed:
rpm -qa | grep iodrive
2. To upgrade the driver, you must uninstall the existing driver, utilities and firmware before installing
the new versions. Use the U parameter in the RPM installation command string to automatically
uninstall the old versions as part of the command task.
To upgrade the driver, see IO Accelerator for BladeSystem c-Class user guide for complete information.
NOTE:
Instructions provided with the new code define what you need to do with each release. Make sure
you read the release notes as well as the install instructions and User Guide to ensure no loss of data.
Determining current Windows version
1. Open Device Manager by right-clicking My Computer, and then selecting Properties>Device
Manager.
2. To upgrade the driver, see IO Accelerator for BladeSystem c-Class user guide for more information.
HP StorageWorks IO Accelerator Driver 1.2.7 9