Setting Up A Standard Pa; Overview; Cabling - Dynacord PowerMate 1000-3 Owner's Manual

3
P M
OWER ATE

5 Setting up a standard PA

5.1 Overview

In the following we would like to explain how to install a
typical sound reinforcement system in passive
configuration. The necessary equipment is:
Illustration 5-1: Setting up a standard PA-system

5.2 Cabling

The mains supply cord comes with the PowerMate. The
quality of all other cables lies in your responsibility. Care-
fully chosen high quality cables are the best precaution to
prevent later problems during live operation. The follow-
ing wiring alternatives are recommended to provide trou-
ble free operation of your system.
40
• 1 PowerMate1000
• 2 HI cabinets, e.g. D 12-3
• 2 LO cabinets, e.g. Sub 115
• 2 Speaker pole-stands or 2 connection rods
• 2 active stage monitor speakers, e.g. AM 12
• 2 Speakon cables, 8 meters
• 2 Speakon cables, 2 meters
• 2 XLR LF cables
S C
PEAKER ABLES
From our experience as a manufacturer of loudspeaker
systems we know that flexible cables with a rubber jacket
2
and a diameter of 2.5mm per conductor, used in combi-
nation with Speakon plugs and sockets, are the best
choice to guarantee the optimal connection of loudspeak-
er systems. Connect the Speakon plugs according to the
corresponding diagram on the PowerMate's rear panel.
We recommend using 4-wire cables where also the pins