Serial Interface Setup Mode - Panasonic KX-P1131E Operating Instructions Manual

Using the Control Panel

Serial Interface Setup Mode

The following items can be set in the Interface Setup mode through the Control Panel: Data length, Baud rate,
Parity, Protocol and Signal polarity.
You can select and change the desired item according to the status of the FONT/PITCH indicators.
1.
Load a sheet of paper (Page 20), and turn the power off.
2.
While pressing
Both FONT indicators and the HIGH SPEED indicator will be blinking. The current settings will be printed
automatically.
3.
Press
FONT
Each time you press
status of the FONT indicators (on, off, blinking).
4.
Press
PITCH
The item's status will change each time you press
To change additional settings, repeat steps 3 and 4.
A FONT indicators:
Press
FONT
Item
Data length
Baud rate
Parity
Protocol
Signal Polarity
FONT/PITCH indicators condition:
= light is lit.
5.
Press
LOAD/PARK
The FONT indicators will go off and the current conditions will print.
Note
•
To return all current settings to the factory settings, follow the steps below.
1.
While pressing
2.
Press
3.
Press
36 Operating Instructions
, turn the power on to enter the Interface Setup mode.
PITCH
to select the item.
, you will advance to the next item. Select the desired item according to the
FONT
to set the item's status.
B PITCH indicators:
. Press
PITCH
A
8Bit
300
None
DTR XON/XOFF
Mark
= light is out.
to exit the Interface Setup mode.
LOAD/PARK
.
TEAR OFF
to exit the Initial Setup mode.
LOAD/PARK
. See the table below to verify desired status.
PITCH
.
Setting
7Bit —
600 1200
Ignore Odd
—
Space —
= light is blinking.
, turn the power on, then release.
B
— —
2400 4800
Even —
— —
— —
— —
9600 19200
— —
— —
— —