Epson 2080 - LQ B/W Dot-matrix Printer Service Manual page 24

LQ-2080
The following figure shows the data flow from the host computer to the
printhead. Data sent from the host computer is converted to image data
and transmitted to the printhead through the gate array.
Figure 2-2. Data Flow
Operating Principles
The table below lists the each function of the main components of the
C273 Main Board.
Table 2-1. Functions of the Main Board
IC Location
CPU IC 4
Gate Array IC 3
EEPROM IC 5
ROM IC 10
RAM IC 8
CG IC 6
SLA7024M IC 11
A2917SEB IC 12
Control Circuit
Function
Receives data from the host computer and sends it
to the input buffer in RAM (under interrupt
processing control). Extends the input data held in
the buffer to create image data. Loads this image
data to the image buffer in RAM. Transfers the
image data to the printhead driver circuit.
Controls the functions below:
• Controls output data from the internal block
• Memory management
• Address latch of the address/data bus from the
CPU
• Clock control unit
• Bit manipulation
• Interface control
• Expanded parallel port
• Printhead control
• Motor control
An electrically writable and erasable ROM used to
hold information such as the TOF position and
bidirectional adjustment value.
The ROM contains the program that runs the CPU
and holds the character design (also called the
character generator).
The RAM contains the CPU working area and the
buffers.
The CG contains the bitmap fonts for each character
table.
Driver circuit for the CR motor.
Driver circuit for the PF motor.
Revision A
24