Download Print this page

Bosch SHE23R52UC Getting Started Manual

Short instructions
Hide thumbs Also See for SHE23R52UC:

Advertisement

Available languages

Available languages

Getting started with your new dishwasher.
1
Adding Rinse Aid
— Rinse aid is necessary to improve drying results.
— Add rinse aid when the Rinse Aid LED on the
control panel illuminates.
— Lift the tab to open the rinse aid reservoir and
add liquid rinse aid by pouring over the arrow.
— Wipe up any excess rinse aid that may puddle.
2
Adjust Amount of Rinse Aid Dispensed
— Turn the arrow inside the rinse aid dispenser to
adjust the amount of rinse aid dispensed.
To decrease
streaks on glass
To Optimize Drying Performance
1 - Always use Rinse Aid
2 - Use Auto Cycle (certain models)

Frequently Asked Questions

Dishes are not drying properly: Refer to section above.
Odor: Debris at the bottom of the dishwasher or in the door
seal can cause odor. Clean both according to instructions in the
Use and Care Manual.
Dishwasher still on after cycle ends: Default factory settings
have the dishwasher stay powered on after a cycle ends.
Customer must manually turn the dishwasher off. Dishwasher
must be powered on again in order to start a new cycle.
ALWAYS READ YOUR USE AND CARE MANUAL FOR DETAILED
INSTRUCTIONS AND IMPORTANT SAFETY NOTICES.
9000643616 Rev A 3/11
Adding Detergent
3
— Use fresh powdered detergent or detergent tabs
for best results.
— 1 tablespoon will clean most loads
— 3 tablespoon max, do not overfill
— When using detergent tabs, lay them flat to avoid
contact with the cover.
To close the cover:
— Place finger on arrow and slide
cover fully left.
— Push rear end of cover down
firmly until it clicks.
To open the cover:
— Push the blue button inward
(not down) and cover will slide
open.
To Start the Dishwasher
4
— Press the On/Off button to turn dishwasher on.
— Select a cycle and desired option if applicable.
— Cycle will begin.
To decrease
Cancelling a cycle / Reset the dishwasher
spots on glass
If you need to cancel a cycle or the dishwasher control panel seems to not respond,
cancel or reset by following these steps.
— Press and hold the two Cancel/Reset
buttons for 3 seconds.
— Wait about 1 minute while the dish-
washer drains.
To close the cover
— Press the On/Off button. You may
Cycle Descriptions
Heavy: Uses higher water temperature and pressure to remove
baked-on foods
Auto*: Reads the size and soil of each load, adjusting water and
heat to the ideal balance for optimum cleaning results
Normal: Cleans normal loads with loosely attached, normal
soiling
Delicate*: Uses lower water temperature and pressure, safe for
delicate or heirloom dishware
Express*: Cleans lightly soiled loads with reduced wash time
Rinse & Hold: Rinses the soil off of a partial load and holds the
dishes until you are ready to run a full load
* Available wash cycles vary by model
To Contact Customer Service
Call the toll free Customer Service number, 1-800-944-2904.
Before calling, locate the model number and serial number on
the label on the inside of the dishwasher door.
3 Tbsp. maximum
2 Tbsp. (25ml)
1 Tbsp. (15ml)
To open the cover
2
now start a new cycle. If you choose
to start a new cycle, turn the unit on
again and select a cycle.
Cancel/Reset

Advertisement

loading

Summary of Contents for Bosch SHE23R52UC

  • Page 1: Frequently Asked Questions

    Getting started with your new dishwasher. Adding Detergent Adding Rinse Aid — Rinse aid is necessary to improve drying results. — Use fresh powdered detergent or detergent tabs 3 Tbsp. maximum for best results. — Add rinse aid when the Rinse Aid LED on the 2 Tbsp.
  • Page 2: Programmes De Lavage

    Fonctionnement de votre nouveau lave-vaisselle. Le liquide de rinçage Ajout de détergent — Pour obtenir un séchage adéquat, toujours — Utiliser les étiquettes détersives ou détersives 3 Tbsp. maximum fraîches pour les meilleurs résultats. utiliser un agent de rinçage liquide. 2 Tbsp.

This manual is also suitable for:

She23r55ucShe23r56uc