Tascam HD-P2 Quick Start Manual

»

First Recording

Apply power
Connect the AC power adaptor to your HD-P2; turn
it ON by momentarily pressing the spring-loaded
p o w e r s w i t c h . T h e H D - P 2 w i l l p o w e r u p
immediately. The HD-P2's operating system is
stored in internal memory, not the CF card, so you
can turn on the HD-P2 without a CF card inserted.
Adjust the Display
Press the key. Turn the
DISPLAY
adjust Contrast for optimal viewing. Press the
key again. Turn the
DISPLAY
adjust Brightness. Press the
adjustments. These settings are remembered when
the unit is power cycled.
Insert Media
Insert a media card into the media slot. The HD-P2
will ask if you would like to format the media. If
this is the first time the media has been used with
the HD-P2 (and it has no other data you wish to
keep) press the
SELECT
Once formatting is complete the HD-P2 will make
a default project (PROJ0001) and return to the main
screen.

Record Audio

Flip the and
LEFT INPUT
(top of unit) to . Set the
MIC
Press the key to enter Monitor mode and
PAUSE
while speaking into the Microphone adjust the input
Levels using the on-screen meters. Press the
key and speak into the microphone for a short test.
Press the key when you are done.
STOP
Play Audio
Return to the beginning of the audio you just
recorded by pressing the
key. Press the
PLAY
Ô
(Headset) level control to hear the audio in the
speaker, or headset if one is plugged in. Note that
connecting a headset disables the built-in speaker.
wheel to
DATA
wheel to
DATA
key to end
CANCEL
key to format the media.
switches
RIGHT INPUT
switch to
MIC INT
REC
+ or
STOP REW LOCATE
key. Adjust the Monitor
HD-P2

Create a New Project

1. Hold the
MENU
2. Use the
DATA
Project
3. Press the
SELECT
4. Use the
DATA
�emplate
5. Press the
SELECT
6. Press the
SELECT
wait two seconds)

Load A Project

1. Hold the
MENU
2. Use the
DATA
be loaded
3. Press the
SELECT
4. Load Project should already be selected
5. Press the
SELECT

Delete A Project

1. Hold the
MENU
2. Use the
DATA
be deleted
3. Press the
SELECT
4. Use the
DATA
5. Press the
SELECT
.
6. Press the
SELECT
action cannot be undone

Rename A Project

1. Press the
MENU
2. Use the
DATA
Menu (this references the currently loaded
project)
3. Press the
SELECT
4. Use the
DATA
5. Press the
SELECT
interface
Quick Start Guide
key and press the
PROJECT
wheel to scroll to Create New
key
wheel to scroll to Use Default
key
key again to confirm (or
key and press the
PROJECT
wheel to scroll to the project to
key
key
key and press the
PROJECT
wheel to scroll to the project to
key
wheel to scroll to Delete
key
key again to confirm this
key
wheel to scroll to Project
key
wheel to scroll to �ename
key to enter the naming
key
key
key
1