Connections - Yamaha NS-IW960 - Speaker - 50 Watt Owner's Manual

• Connect the push-type input terminals at the rear of the speakers to the speaker output terminals of the
receiver.
• Connect the (+) terminals on the receiver and speakers using the corresponding side of the cable. Connect
the (−) terminals on both components using the other side of the cable.
Notes:
• Make sure that the bare wires are not touching each other as this could damage the speaker and receiver.
• Connect one speaker to the left terminals of your receiver, and another speaker to the right terminals,
making sure no to reverse the polarity (+, −). If one speaker is connected with reversed polarity, the sound
will be unnatural and lack bass.
How to connect
•
1 Press and hold down the speaker terminal.
2 Insert the bare wire.
coating at the extremity of each speaker cable
by twisting the coating off.
3 Release the terminal. Test the firmness of the
connection by pulling lightly on the cable at the
terminal.
1
Black (−)
(−)
6

CONNECTIONS

Receiver
+ −
Remove the insulation
Red (+)
2
(+)
NS-IW960
−
When using a banana plug
•
1 Insert the banana plug into the top of the
terminal as shown below:
1
+
Banana plug