Dell PowerEdge 2550 Rack Installation Instructions page 32

Installing the Slide Assemblies in the Rack
NOTE: If Dell installed the slide assemblies, you can skip this section.
At the front of the rack cabinet, position one of the slide assemblies so that its
1
mounting bracket flange fits between the marks or tape you placed on the rack,
marking the upper and lower edges of the template (see Figure 1-19).
The hooks on the mounting bracket should align with the marks you made from the
2
V-shaped notches in the template.
Align the slide-assembly mounting-bracket flange (on the front of the slide assembly)
3
with the square holes in the front vertical rail (see Figure 1-20).
Push forward until the mounting tabs are secure in the square holes on the vertical rail
4
and the push-button clicks and pops out.
Push back on the back slide assembly mounting bracket flange until the mounting tabs
5
lock into the square holes on the back vertical rail.
Repeat steps 1 through 7 for the remaining slide assembly on the other side of
6
the rack.
1-26 Rac k I n st allat io n G uide