Part Names Of The Projector; Attaching The Lens Cap; Attaching The Supplied Carrying Handle - Dukane 8766 User Manual

Part Names of the Projector

Monaural Speaker (1W)
Lamp Cover (See page E-30)
Lamp Cover Screw
Ventilation (outlet)
Heated air is exhausted from here
Adjustable Tilt Foot Lever
(See page E-18)
Adjustable Tilt Foot (See page E-18)
Ventilation (inlet) / Filter Cover (inlet)
* This security slot supports the MicroSaver
trademarked and owned by Kensington Microware Inc.

Attaching the lens cap

To attach the lens cap to the bottom with the supplied string and rivet:
1. Thread the string through the hole on the lens cap and then tie a knot
in the string.
2. Use the rivet to attach the
string to the bottom of the
projector.
Main Power Switch
When you plug the supplied power cable into
an active wall outlet and turn on the Main
Power switch, the POWER indicator turns
orange and the projector is in standby mode.
(See page E-17)
®
Security System. MicroSaver
Controls (See page E-7)
Remote Sensor (See page E-10)
®
is a registered trademark of Kensington Microware Inc. The logo is

Attaching the supplied carrying handle

You can carry the projector by attaching the supplied carrying handle
securely to the projector.
To attach the supplied carrying handle, use the supplied flathead screw-
driver and two screws.
CAUTION:
When carrying the projector by the carrying handle, make sure the
two screws that attach the carrying handle to the projector cabinet
are tight.
E-6
Zoom Lever
Focus Ring
Lens
Adjustable Tilt Foot Lever
(See page E-18)
Adjustable Tilt Foot
(See page E-18)
Lens Cap
Remote Sensor
(See page E-10)
Built-in Security Slot (
AC Input
Connect the supplied power cable's two-
pin plug here, and plug the other end into
an active wall outlet. (See page E-16)
)*