Table of Contents
Advertisement
TROUBLESHOOTING
This section helps you resolve problems you may encounter while setting up or using the projector.
Power Indicator
Indicator Condition
Blinking light
Green blinking
Orange blinking
Green
Steady light
Orange
Status Indicator
Indicator Condition
Blinking light
Red blinking
Green blinking
Steady light
Orange
Lamp Indicator
Indicator Condition
Blinking light
Red
Steady light
Red
Green
Off
0.5 sec ON,
0.5 sec OFF
0.5 sec ON,
0.5 sec OFF
Off
1 cycle (0.5 sec ON,
2.5 sec OFF)
2 cycle (0.5 sec ON,
0.5 sec OFF)
4 cycle (0.5 sec ON,
0.5 sec OFF)
6 cycle (0.5 sec ON,
0.5 sec OFF)
Off
Projector Condition
The main power is off
The projector is getting ready
to turn on.
The projector is cooling down.
The projector is turned on.
The projector is in Standby.
Projector Condition
Normal
Lamp cover error or lamp
housing error
Temperature error
Fan error
Lamp error
Re-firing the lamp
Control key locked
Projector Condition
Normal
Lamp has reached its end of
life. Lamp replacement mes-
sage will be displayed.
Lamp has been used beyond
its limit. The projector will not
turn on until the lamp is re-
placed.
Lamp mode is set to Eco mode
E-32
Note
–
Wait for a moment.
Wait for a moment.
–
–
Note
–
Replace the lamp cover or
lamp housing correctly.
The projector is overheated.
Move the projector to a cooler
location.
Fans will not work correctly.
Lamp fails to light. Wait a full
minute and then turn on again.
The projector is re-firing.
You have pressed control
panel key when Control Key
Lock is enabled.
Note
–
Replace the lamp.
Replace the lamp.
–
Advertisement
Table of Contents
