Table of Contents
Advertisement
Red LED behavior and projector errors
If the projector is not functioning properly and the red LED is blinking, con-
sult Table 2 to determine a possible cause. There are two second pauses
between the blinking cycles. Visit our website for more details on the red
LED error codes. See the inside back cover for contact information.
Red LED Behavior
One (1) blink
Two (2) blinks
Three (3) blinks
Four (4) blinks
Five (5) blinks
Table 2:
Explanation
The lamp won't strike after five (5)
attempts. Check the lamp and lamp door
installations for loose connections.
The lamp counter hours have exceeded
lamp life hours. Replace the lamp and
reset the lamp hours counter.
The projector has shut down the lamp.
Turn the projector off and wait one
minute, then turn the projector on. If the
lamp does not turn on, replace the lamp.
Contact Technical Support for repair if
replacing the lamp does not solve the
problem.
The fan has failed. Contact Technical Sup-
port for repair.
The projector is overheating. Check for a
blocked air vent. Contact Technical Sup-
port for repair if clearing the air vents
does not solve the problem.
Projected image size
Minimum
Distance
Diagonal
to screen
(feet/m)
(feet/m)
throw
ratio 1.53
5/1.5
3.3/1
10/3
6.5/2
15/4.6
9.8/3
20/6.1
13/4
30/9.1
19.5/5.9
32.8/10
21.3/6.5
NOTE: Visit our website for an interactive image size calculator.
42
Table 3:
Image sizes
Maximum
Minimum
Diagonal
Horizontal
(feet/m)
(feet/m)
throw ratio 1.28
throw ratio 1.91
4/1.2
2.6/0.8
7.8/2.4
5.2/1.6
11.7/3.6
7.8/2.4
15.5/4.7
10.4/3.2
23.2/7.1
15.6/4.8
25.4/7.7
17/5.2
Maximum
Horizontal
(feet/m)
throw ratio 1.60
3.2/1
6.3/1.9
9.3/2.8
12.4/3.8
18.6/5.7
20.3/6.2
Advertisement
Table of Contents
