Setup Menu; D-Shift; Keystone - Hitachi CP-AW250N User Manual

SETUP menu

SETUP menu
From the SETUP menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons, and
press the ► cursor button or ENTER button to
execute the item. Then perform it according to the
following table.
Item
D-ZOOM

D-SHIFT

PICT. POSIT. H

KEYSTONE

(continued on next page)
42
Using the ◄/► cursor buttons adjusts the magnification ratio.
Small ó Large
• The on-screen menu might be displayed outside of the image
display area depending on the adjustment value of the ASPECT,
D-ZOOM, KEYSTONE and
of ASPECT, D-ZOOM,
the symptom.
Using the ◄/►/▲/▼ cursor buttons adjusts the picture position.
• The D-SHIFT adjustment values are not valid when the D-ZOOM
is set to 320 (full screen).
Using the ▲/▼ cursor buttons selects the horizontal picture
position.
LEFT ó MID ó RIGHT
The PICTURE POSITION is not changed if any of the following
cases apply.
• The ASPECT is set to 16:9 or 16:10.
• The input signal has an aspect ratio of 16:9, 16:10 or verticallly
smaller than 16:10, while ASPECT is set to NORMAL.
• Horizontal size of the displayed image is full on the effective
display area, while the ASPECT is set to NATIVE.
• One of the following messages is displayed on the screen:
"NO INPUT IS DETECTED"
"SYNC IS OUT OF RANGE"
"INVALID SCAN FREQ."
• The BLANK or TEMPLATE function is selected.
Using the ◄/► buttons corrects the vertical keystone distortion.
Shrink the bottom of the image ó Shrink the top of the image
• The adjustable range of this function will vary among inputs. For
some input, this function may not work well.
• This function will be unavailable when the Transition Detector is on
(74) or the PERFECT FIT (43) is adjusted.
Description
KEYSTONE. Changing the values
KEYSTONE and KEYSTONE may fix