Cisco PIX 520 - PIX Firewall 520 User Manual page 23

Chapter 5 PIX 520
Reconnect power to the PIX 520. After wiring the DC power supply, remove the tape from the circuit
Step 8
breaker switch handle and reinstate power by moving the handle of the circuit breaker to the ON position.
Step 9 Insert the PIX 520 system diskette in the drive at the front of the unit.
If needed, install the interface boards as described in the
Step 10
section on page
Step 11 Power on the unit from the switch at the rear of the unit.
If you need to power cycle the DC PIX security appliance, wait at least five seconds between powering
Note
off the unit and powering it back on.
78-15170-02
5-15.
"Installing a Circuit Board in the PIX 520"
Cisco PIX Security Appliance Hardware Installation Guide
Installing the PIX 520 DC Model
5-23