Internal Connectors - Asus K8U-X - Socket 754 Motherboard User Manual

1.10.2 Internal connectors

This section describes and illustrates the internal connectors on the
motherboard.
1. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
This connector supports the provided UltraATA133 IDE hard disk ribbon
cable. Connect the cableʼs blue connector to the primary (recommended) or
secondary IDE connector, then connect the gray connector to the UltraATA133
slave device (hard disk drive) and the black connector to the UltraATA133
master device.
1. Follow the hard disk drive documentation when setting the device
in master or slave mode.
2. Pin 20 on each IDE connector is removed to match the covered hole
on the UltraATA cable connector. This prevents incorrect orientation
when you connect the cables.
3. The hole near the blue connector on the UltraATA cable is intentional.
K8U-X IDE connectors
1-20
®
PIN 1
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
Note: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
Chapter 1: Product Introduction