Asus E35M1-I User Manual page 22

4. Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~6)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
E35M1-I SATA 6.0Gb/s connectors
• These connectors are set to [IDE Mode] by default. In IDE mode, you can connect Serial
• When using hot-plug and NCQ, set the OnChip SATA Type item in the BIOS to [AHCI
5. USB 2.0 connectors (10-1 pin USB78, USB910, USB1112)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specification that supports up to
480 Mbps connection speed.
E35M1-I USB2.0 connectors
Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard!
The USB module cable is purchased separately.
1-12
SATA6G_2
SATA6G_1
ATA boot/data hard disk drives to these connectors.
Mode]. See section 2.5.2 SATA Configuration for details.
USB1112
USB910
SATA6G_4 SATA6G_6
SATA6G_3 SATA6G_5
PIN 1
PIN 1 PIN 1
USB78
ASUS E35M1-I