Advertisement
2.3
Mounting the detector
Use the hardware provided. The plastic mounting anchors
require a 3/16 (5 mm) hole.
Surface mounting
1 Tamper Screw
Corner Mounting
2.4
Wiring the detector
Wire sizes between 16 AWG and 26 AWG (0.2 mm
mm
) are permitted. Install the wiring using the approprate
2
knock-outs and tie-downs.
© 2009 Bosch Security Systems, Inc.
�
and 1
2
2.5
Wiring the terminal blocks
The detector has two terminal blocks. One block is used for
primary wiring; the other has two spare terminals. The two
spare terminals are normally used as tie points for the EOL
resistor.
����� ������
�
� �� �� �
�
��������������
�����������
�
Do not attempt to remove the terminal blocks from
the cover. This could result in permanent damage
to the detector.
����������
�������
� �� ��� �� ��
��������������������
�����
���������
3
Advertisement
