Electrolux EI30MO45GS - 30" Microwave Brochure & Specs page 2

Built-In Microwave
EI30MO45G S
18 1 / "
16
Allow at least
21" clearance for door
depth when open
30" Built-In Microwave Specifications
Microwave Product Weight – 48 Lbs.
•
Voltage Rating – 120V / 60 Hz / 15 or 20 Amps
•
Connected Load (kW Rating) @ 120 Volts = 1.5 kW (For use on
•
adequately wired 120V, dedicated circuit having 2-wire service with a
separate ground wire. Appliance must be grounded for safe operation.)
Amps @ 120 Volts = 13 Amps
•
Always consult local and /or national electric codes.
•
Allow 21" minimum clearance for 90° door swing.
•
Built-in installation requires use of 30" Trim Kit (EI30MO45TK) which is
•
supplied and includes Stainless Steel Faceplate and Bottom Duct
Assembly – shipped in separate box.
Minimum 20" deep oven cutout dimension is critical for proper installation
•
for oven and faceplate to fit flush against cabinet front.
Consult local building code, in the event that cutout opening may be
•
required to be enclosed with sides, ceiling and rear partition.
250 Bobby Jones Expressway
USA
•
CANADA 5855 Terry Fox Way Mississauga, ON L5V 3E4
• •
EI30MO45G 01/08
*Note: When used in combination with
another Electrolux built-in product, a
minimum clearance of 2
bottom of Built-In Microwave cutout to top
edge of companion product's faceplate,
leaving a 2" visible gap between both
product faceplates
Faceplate
24 "
13 3 /
15 3 / "
4
30"
2 5 / "
16
120V /60Hz
grounded outlet
Bottom Duct Assembly
16 1 / "
4
min.
16 3 / "
8
max.
25 1 / "min.
4
3
25 / "max.
8
Augusta, GA 30907 1-877 -4electrolux (1-877 -435-3287)
• •
1-800-265-8352
•
© 2008 Electrolux Major Appliances, NA
7 / " required from
8
1
16 / "
4
min.
25
3
16 / "
8
25
max.
Power
cord
location
"
8
(right 2" (visible
top rear) gap)*
6"
4"
Outlet should
NOT be located
4"
within shaded
area
20" min.
Full base of solid plywood or similar material required, capable
•
of supporting 100 Lbs.
Base must be level and front of cabinet square for proper operation.
•
Grounded outlet should NOT be located in shaded area, as indicated.
•
Can NOT be installed above any gas wall oven.
•
Built-In Convection Microwave can be built in alone or is approved to be
•
used in combination with any Electrolux Electric Single Wall Oven and / or
Warmer Drawer.
When used in combination with another Electrolux built-in product, a
•
minimum clearance of 2-7/8" required from bottom of Built-In Microwave
cutout to top edge of companion product's faceplate, leaving a 2" visible
gap between both product faceplates.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxusa.com for detailed instructions.
electroluxappliances.com
•
electroluxappliances.ca
•
30"min.
1 / "min.
4
3
/ " max.
8
20"
min.
Full
plywood
7 / "
base
8
Faceplate
required
overlap
to support
100 lbs.
High standards of quality at Electrolux Major Appliances mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
Printed in the U.S.A.