Garmin GPSMAP 420 - Marine GPS Receiver Installation Instructions Manual page 2

Flush mount kit instructions and template (multilingual)

Hide thumbs Also See for GPSMAP 420 - Marine GPS Receiver:

Available languages

3. Install the unit in the opening (see Figure 2):

• Place the unit housing in the recently cut hole in the mounting surface.

• Slide the tension mount arms onto the hex bolts and secure them with the (4) wing nuts.

• Tighten the (4) wing nuts to secure the unit housing to the mounting surface. Be careful not to overtighten.

Assembled unit and

flush mount hardware

NOTE: If you are installing a Fishfinder 400C, the wiring harness must be connected to the boat's power supply and transducer per the installation

instructions included with the unit.

NOTE: If you are installing a GPSMAP 400 series unit, you must connect the wiring harness to the boat's power supply, GPS antenna, XM antenna

(if applicable), and transducer (if applicable) per the installation instructions included with the unit.

Tension mount brackets

Figure 2

Wing nuts