Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION INSTRUCTIONS
[] Level adjustment
/_gher
Adjustable feet
Adjustable feet
• Leveling the washing machine properly prevents
excessive noise and vibration
Installthe appliance on a solid and level floor surface,
preferably in a corner of the room
• If the floor is uneven,
adjust the adjustable
feet as
required
(Do not insert pieces of wood, etc, under the
feet )
NOTE: Extend the feet no more than
necessary
to level
the _xasher.
The mine
the feet are extended,
file
more the washer
will vibrate°
• Make sure that all four feet are stable and resting on
the floor and then check that the appliance
is perfectly
level (Use a level)
• After the washer
is level, tighten the lock nuts up
against
of the base of the washer
All lock nuts must
be tightened
• It is critical to adjust the feet perfectly,
This must be
dene while the washer
is spinning
with a load
Use the
wrench
(supplied)
to adjust the feet until there is no
vibration
Then tighten the lock nuts to prevent
further
adjustmenL
N(Yl E: If there are vibration
and noise during
the spin
cycle, re-cheek the leveling *ff the w=L, cber,
adjust
the feet as required,
and tighten the lock nuts
securely
to prevent
changes in adjust merit.
Run tile washer
with a test toad to make certain
your washer
is properly leveled.
Put
approximately
6 potlmls nf laundry in the
machine.
Then, press POWER,
RINSE+SPIN,
alto
START!PAUSE,
in that order.
When the macbine
spins at high speed, verify thai it is stable,
if not,
adjust
tile feet accordingly°
* Diagonal Check
When pushing down ate edges of the washing mocldne
top plate diagonally, the machine should not move up
and down at all (Please, cbcek both tb_rectlons.)
If the machine rocks when pusblng the machine top plate
diagonally, adjust the feet ogaln.
Advertisement
Table of Contents
