Table of Contents
Advertisement
Care & Cleaning
Inside
Cleaning
(Aggressive)
In cases where SYSTEM CLEAN cycle along with
care and cleaning of rubber gasket folds isn't
done, and severe odor, mold, mildew, or residue
buildup have developed, follow the below cleaning
procedure to help alleviate the problem.
CLEANING PROCEDURE
- Washer Drum
Ensure the wash tub is empty (or no clothes load).
Open the detergent drawer and pour eight (8)
cups of bleach into the "MAIN WASH" detergent
compartment.
Select SYSTEM CLEAN cycle in the
set prefs section under the options scroll buttons.
Upon cycle completion
inspect the interior of
the washer to see if the odor/residue
has been
eliminated. If any additional cleaning is required,
repeat the above procedure. This may take
several cycles depending on the severity of the
odor/residue.
You may observe some remaining
discoloration
due to the long term effects of this
residue.
For especially contaminated
areas visible inside
the drum (including the front rubber seal), these
areas might be more effectively cleaned by
spraying a Bleach Cleaner on a scrub brush, soft
sponge, or towel and scrubbing.
REMOVE "LIQUID
DISPENSER CUP
select
select
If odor is still left after bleach cycle(s) and bleach
cleaner, open the detergent drawer and pour
one (1) pouch of TIDE@ WASHING MACHINE
CLEANER in detergent drawer. Select SYSTEM
CLEAN cycle as above and start the washer.
For best
results
Immediately follow up with a Spin Only
cycle. Select Extra Rinse on Max spin
speed with no detergent or bleach to
help clear any residual bleach left after
the SYSTEM CLEAN cycle.
"MAIN WASH"
CO M PARTM ENT
Advertisement
Table of Contents
