Recording From A Transcription Unit - TANDBERG TR-2075 Operating Instructions Manual

Recording from a transcription unit

Connect a transcription unit (or record player) to the
PHONO 1 socket and a tape recorder to the TAPE 1 socket
at the hack of the receiver. Put the tape recorder into the
RECORD mode but do not start it. Start the transcription unit
and depress the PHONO 1 button, Let the record run for a
minute or two and note the indication on the tape recorder
input level meter. Adjust the input level controls on the tape
recorder to take account of any peaks in the output from the
record. Stop the transcription unit.
Now you can start the proper recording. Start the
transcription unit and the tape recorder. The recording will
be unaffected by all the other audio
controls. See page 22 for advice on monitoring.
Two transcription units
A second transcription unit can be connected to the
PHONO 2 socket so that when the record on (the first
transcription unit comes to an end a second record can be
recorded without stopping the tape recorder, provided
that you know there are no output peaks on the second
record greater than those on the first record.
PROCEDURE.
As the first record ends, start the second transcription
unit and depress PHONO 2 button.
Two tape recorders
A second tape recorder can be connected to the TAPE 2 socket
and recording can take place on this machine at the same time.
The trial and error procedure for achieving the correct setting
of the level controls can be carried out for the two tape
recorders also at the same time. See page 22 for advice on
monitoring.
WARNING!
Depressing the PREAMP REC button reduces the
amplification by 30 dB. Therefore be careful not to release the
button when playing at high volume. Otherwise you may
damage your speakers.
19