Advertisement
Quick Links
2U AUTOLOADER
QUICK START GUIDE
Step 1: Unpack the Autoloader
a.
Look for markings on the shipping carton that indicate the top. If
necessary, position the carton so that it is top-side up.
b.
Using scissors, a utility knife, or other appropriate tool, carefully cut
the packing tape along the length and ends of the carton.
c.
Remove the accessories box from the shipping carton and check
the contents. The accessories box contains the following items:
• SCSI cable and terminator
• Manual CD & Quick Start Guide (Hardcopy)
• Power cord (EU & US version)
If this is a rackmount installation, check the rack kit contents (has
to be purchased separately). The rack kit contains the following:
• Hardware kit with clip nuts and bolts
• Mounting rails
• Fixing flanges
d.
Lift the Autoloader and padding out of the box and place it on a
work surface, top facing up.
e.
Carefully remove the foam packaging from the Autoloader and
then remove the bag.
1
Rev. 1.0, June 2004
Advertisement
Related Manuals for TANDBERG 2U AUTOLOADER
Summary of Contents for TANDBERG 2U AUTOLOADER
- Page 1 2U AUTOLOADER QUICK START GUIDE Step 1: Unpack the Autoloader Look for markings on the shipping carton that indicate the top. If necessary, position the carton so that it is top-side up. Using scissors, a utility knife, or other appropriate tool, carefully cut the packing tape along the length and ends of the carton.
- Page 2 Step 2: Choose a Location Select a location for the Autoloader that has adequate clearance for ventilation, minimal dust and debris, and an appropriate power source nearby. If this is a standalone installation, select a location that is flat, sturdy, and level.
- Page 3 Step 4: Cabling the Autoloader a. Ensure that all devices on the SCSI bus are powered off. b. Attach a SCSI cable from the SCSI bus to one of the SCSI connectors on the back panel of the Autoloader. c. If the Autoloader is the last device on the SCSI bus (or the only device), attach a SCSI terminator to the other SCSI connector on the back panel of the Autoloader.
- Page 4 Step 6: Turn on the Autoloader Turn on the Autoloader by pressing the power button on the front panel. Power on the host and all attached SCSI devices. Use the eraser end of a pencil or something similar to press the left side of the power switch.
- Page 5 6. Repeat step 4 to 7, until all cartridges are imported. Drive empty 12345678 7. Power up your host computer. 8. Verify your backup software. Exporting Cartridges. Unload tape cartridges from the Autoloader by using the Export command from the front panel. The selected cartridge automatically ejects.
- Page 6 Rev. 1.0, June 2004...
-
Page 7: Support Contact Information
Poway CA 92064 Phone: 001 – (0)858 – 726 0277 Fax: 001 – (0)858 – 726 0278 ASIA TANDBERG Data Pte. Ltd. (main office for ASIA) 20 Bendemeer Road #04-05 Cyberhub Singapore 339914 Phone: 0065 – (0)6396 – 0786 Fax: 0065 –...