Advertisement
Available languages
Available languages
Always follow the fabric manufacturer's care label when laundering.
Sorting and Loading Hints
As a general rule, if clothes are sorted properly for
the washer, they are sorted properly for the dryer.
Do not add fabric softener sheets once the load
has become warm. They may cause fabric softener
stains. Bounce
have been approved for use in all GE Dryers when
used in accordance with the manufacturer's
instructions.
Care and Cleaning of the Dryer
compounds with a damp cloth. Dryer control
panel and finishes may be damaged by some
laundry pretreatment soil and stain remover
products. Apply these products away from the
dryer. The fabric may then be washed and dried
normally. Damage to your dryer caused by these
products is not covered by your warranty.
use. Moisten your fingers and reach into the filter
opening. Run your fingers across the filter. Have a
qualified technician vacuum the lint from the dryer
once a year.
Fabric Care Labels
Below are fabric care label "symbols" that affect the clothing you will be laundering.
Machine
wash
cycle
Normal
Water
temperature
Bleach
symbols
Any bleach
(when needed)
®
Fabric Conditioner Dryer Sheets
Wipe or dust any spills or washing
Clean the lint filter before each
Permanent Press/
Gentle/
Do not wash
Hand wash
wrinkle resistant
delicate
Hot
Warm
Cold/cool
(50°C/120°F)
(40°C/105°F)
(30°C/85°F)
Only non-chlorine bleach
Do not bleach
(when needed)
wrinkling.
woolens, rubber-coated items, plastics, items with
plastic trim and foam-filled items.
use a damp cloth with a mild, non-abrasive cleaner
suitable for stainless steel surfaces. Remove the
cleaner residue, and then dry with a clean cloth.
ducting at least once a year to prevent clogging.
A partially clogged exhaust can lengthen the
drying time.
Turn off electrical supply by disconnecting
the plug from the wall socket.
Disconnect the duct from the dryer.
Vacuum the duct with the hose attachment
and reconnect the duct.
the flaps of the hood move freely when operating.
Make sure that there is not wildlife (birds, insects,
etc.) nesting inside the duct or hood.
Tumble
dry
Dry
Do not wring
Heat
setting
High
Special
instructions
This wastes energy and causes
fiberglass items,
To clean stainless steel surfaces,
Inspect and clean the exhaust
Check from the outside that
Normal
Permanent Press/
Gentle/
Do not tumble dry
wrinkle resistant
delicate
Medium
Low
No heat/air
Line dry/
Dry flat
Drip dry
hang to dry
Do not dry
(used with
do not wash)
In the shade
11
Advertisement
