Advertisement
If a bulb is burned out, replace it
to
help avoid an
accident. If the arrows don't go on at all when you
signal a turn, check for burned-out bulbs and check the
fuse (see "Fuses and Circuit Breakers'' in the Index).
A chime will sound if you leave your turn signal on for
more than 1/2 mile (0.8 km).
Headlamp High/Low Beam
To change your headlamps
from low beam to high
beam, or high to low, pull
the multifunction lever all
the way toward you. Then
release it. When the high
beams are on, a light on the
instrument panel also will
be on.
Windshield Wipers
To control the windshield
wipers, turn the band
marked WIPER. For a
single wiping cycle, turn the
band to MIST. Hold it there
until the wipers start, then
let go. The wipers will stop
after one cycle. If you want
more cycles, hold the band
on MIST longer.
For steady wiping at low speed, turn the band to LO. For
high-speed wiping, turn the band further, to
HI. To
stop
the wipers, turn the band to OFF.
You can set the wiper speed for a long or short delay
between wipes. This can be very useful in light rain or
snow. Turn the band to choose the delay time. The
closer to LO, the shorter the delay.
Be sure to clear ice and snow from the wiper blades
before using them. If they're frozen to the windshield,
carefully loosen or thaw them. If your blades do become
damaged, get new blades or blade inserts.
Advertisement
