Related Manuals for Dolphin DXS410
Summary of Contents for Dolphin DXS410
-
Page 1: Quick Start Guide
Dolphin DXS410 Switch Quick Start Guide Revision 1.0 Revision Information: Dolphin Interconnect Solutions, 225 Cedar Hill Street, Marlborough, MA 01752 www.dolphinics.com... - Page 2 April 2008 Dolphin Interconnect Solutions believes the information in this publication is correct; however, the information is subject to change without notice. Dolphin Interconnect Solutions does not claim that the use of its products in the manner described in this publi- cation will not infringe on any existing or future patent rights, nor do the descriptions contained in this publica- tion imply the granting of licenses to make, use, or sell equipment or software in accordance with the description.
- Page 3 If additional information is required, send email to Dolphin at pci-support@dolphin- ics.com. Refer to the DXS410 Switch Release Notes for any release specific updates.The release notes can be downloaded from our customer support section of www.dolphinics.com. Comments about (and corrections to) this manual can also be sent to pci-support@dol- phinics.com.
-
Page 4: Kit Contents
• High speed data cables 1.2.1 Cable Requirements A high speed data cable is required to connect the DXS410. Dolphin provides the fol- lowing cables to support the DX products (See Table 1–1). Table 1–1 Dolphin Cable Offering Part Number... - Page 5 100V to 240VAC at frequency of 50-60Hz. Figure 1–1 AC Power Inlet 3. Turn on the AC power switch on the front of the DXS410. This will apply AC power to the chassis. 4. The DXS410 switch will go through a self test. You will observe that for 0.5 sec- onds the 10 Port LEDs turn green and that the red alarm LED along with the green power LED turn on.
- Page 6 Note: Connecting cables For x4 operation connect a cable to one or more of the ten DXS410 front ports. Connect the other end of the cable to each targeted device, such as a DXH510 host adapter board. A single cable is required to connect to each device you intend to connect at x4 speeds.
- Page 7 Ports 3 and 4 illustrate a x8 connection with a single LED lit while Ports 5 and 6 illus- trate two independent x4 connections with a LED lit for each port. 10. The switch is now ready to use April 2008...
Need help?
Do you have a question about the DXS410 and is the answer not in the manual?
Questions and answers