Table of Contents
Advertisement
R
Passlock
Your vehicle is equipped with the Passlock
-
theft
deterrent system.
Passlock is a passive theft
enables fuel if the ignition lock cylinder is turned with a
valid key. If a correct key is not used or the ignition lock
cylinder is tampered with, fuel is disabled.
During normal operation, the SECURITY light will go
off approximately five seconds after the key is turned to
the RUN ignition position.
If the engine stalls and the SECURITY light flashes,
wait until the light stops flashing before trying to restart
the engine. Remember to release the key from START
as soon as the engine starts.
If the engine is running and the SECURITY light comes
on, you will be able to restart the engine if you turn the
engine off. However, your Passlock system is not working
properly and must be serviced by your dealer. Your vehicle
is not protected by Passlock at this time. You may also
want to check the fuse (see "Fuses and Circuit Breakers"
in the Index). See your dealer for service.
In an emergency, call the GMC Roadside Assistance
-
-
-
Center at 1
800
GMC
8782 (1
-
-
United States, or 1
800
268
2-20
-
deterrent system. Passlock
-
-
-
800
462
8782) in the
-
6800 in Canada.
New Vehicle "Break
NOTICE:
Your vehicle doesn't need an elaborate
-
"break
in." But it will perform better in the long
run if you follow these guidelines:
D
Keep your speed at 55 mph (88 km/h) or
less for the first 500 miles (805 km).
D
Don't drive at any one speed
--
slow
for the first 500 miles (805 km).
-
Don't make full
throttle starts.
D
Avoid making hard stops for the first
200 miles (322 km) or so. During this time
your new brake linings aren't yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking
time you get new brake linings.
D
Don't tow a trailer during break
"Towing a Trailer" in the Index for
more information.
In"
-
--
fast or
-
in guideline every
-
in. See
yellowblue
Advertisement
Table of Contents
