Table of Contents
Advertisement
Set the head restraints aside for now. You will stow them
in their proper position after you are done folding
the seat.
Pull the seatback forward and fold the seatback down
until it is flat.
Fold the seatback forward
enough to allow removal of
the head restraints. Push and
hold the release buttons at
the bottom of each head
-
restraint height
adjust post
and slide the head
restraint out of the
-
height
adjust tubes.
To return the seat to the passenger position, first remove
the head restraints by sliding them out of the seat
cushion. Lift the seatback up enough to install the head
restraints. Push the seatback rearward all the way. Then,
lower the seat cushion until it latches in position.
After returning the seat to the passenger position, return
the head restraints to the top of the seatback. Pull
forward on the seatback and up on the seat cushion to
make sure that the seat is securely in place.
If the latch plate portion of the center safety belt was put
in the center armrest when the seat was folded, take the
latch plate portion out and place it on the seat. That way,
the center position safety belt will be available for the
center rear seat passenger to use.
yellowblue
Then, stow the head
restraints by sliding them
into the rear of the seat
cushion. Make sure the
posts go in all the way.
1-7
Advertisement
Table of Contents
