Sonos ZP80 User Manual page 20

2-2
Step 1: Connect first ZonePlayer to home network
1. Connect the Ethernet cable from an open port on your router to any of the
Ethernet switch connectors on the back of your ZonePlayer.
Note: You can connect either a ZonePlayer 80 or a ZonePlayer 100 to your router. If
you are going to use speakers in this music zone, you can connect a ZonePlayer 100
to your router. If you want to connect to an external amplifier, or to your computer's
powered speakers, you can connect a ZonePlayer 80 to your router.
• If your modem is currently plugged into the only network interface connector
on your computer, you should install a standard router before continuing. If you
don't have a router, go to http://faq.sonos.com/norouter for instructions.
Or,
• If you have structured (built-in) wiring that connects to a router located else-
where in your home, you can connect the Ethernet cable from a live wall plate
into one of the Ethernet switch connectors on the back of your ZonePlayer.
Chapter 2: ZonePlayer Setup and Operation