Opening Safe For The First Time - Honeywell 2092D - Waterproof Fire Safe Operations & Installation Manual

Opening Safe For The First Time

Important: FIRST TIME ACTIVATION
Your safe is ready for activation. To allow the safe to be opened and to prevent
locking of the safe prior to completing the first-time user activation procedures, a
solenoid deactivation safety device has been installed.
Batteries and Emergency Override Keys
Remove 4 "AA" batteries and 2 Emergency Override Keys. They are
located in the protective Styrofoam insert at the top of the box.
User Activation
Install Batteries
1. Turn handle upwards to the right and pull open the safe door.
2. Slide the battery compartment cover (located inside the
safe at the top of the door) forward and remove. Install
the 4 "AA" batteries. Make sure the batteries are installed
in the proper direction as indicated in the battery
compartment. Slide the cover back into place.
3. After the batteries are correctly installed, the red and green
lights located at the top of the keypad on the front of the safe
will blink twice, the keypad backlight will flash once and
you will hear a single beep.
4. Proceed to Activate Lock.
Important: ENABLE/DISABLE SOUND
Once the batteries are installed, if you do not hear a beep when entering
the factory pre-set Passcode or during the personal Passcode re-programming
process, enter the following key sequence into the digital keypad: #
This will turn the sound on. Repeat the process if you want the sound turned off.
Activate Lock
1. Locate the small plastic Locking Pin on the inside of the
safe door. Grip and pull out completely. Pin can then be
properly discarded.
2. Leave the safe door open and proceed to Electronic
Locking System Test.
2
- +
-
+
GREEN
RED
LIGHT
LIGHT
*
#