BenQ FP94G User Manual page 7

3. Connect the PC video cable.
Do not use both DVI-D cable and D-Sub cable on the
same PC. The only case in which both cables can be
used is if they are connected to two different PCs with
appropriate video systems.
Connect one end of the DVI-D cable to the monitor
DVI-D socket and the other end to the DVI-D port on
your computer. (optional)
The DVI-D format is used for direct digital connection
between source video and digital LCD monitors or
projectors. The digital video signals produce a superior
quality picture than analog video signals.
Connect the plug of the D-Sub cable (at the end without
the ferrite filter) to the monitor D-Sub socket. Connect the
other plug of the D-Sub cable (at the end with the ferrite
filter) to the computer video D-Sub socket.
Tighten all finger screws to prevent the plugs from acci-
dently falling out during use.
4. Connect the power cable to the monitor.
Plug one end of the power cord into the socket labelled
'POWER IN' on the rear of the monitor. Do not connect
the other end to a power point just yet.
5. Turn on the power.
Plug the other end of the power cord into a power point
and turn it on.
Turn on the monitor by pressing the power button on the
front of the monitor.
Turn on the computer too, and follow the instructions in
Section 4:
Getting the most from your BenQ monitor
to install the monitor software.
on page 11
Either
Or
How to assemble your monitor hardware 7