Integrated Usb Full Speed; Low Speed - Metrologic MS9540-38-3 - MS9540 VoyagerCG Installation And User Manual

I
NSTALLING THE
Integrated USB: Full Speed (-40)
1. Turn off the host system.
2. Connect the 10-pin RJ45 male
connector of the USB cable into the
jack on the scanner. You will hear a
'click' when the connection is made.
3. Connect the other end of the USB
cable to the host USB port.
4. Turn on the host system.
As a default, the MS95x0-38 leaves the factory with USB Keyboard
Emulation Mode enabled.
For information on configuring the MS95x0-38 for USB Serial
Emulation Mode, please refer to the USB section of the MetroSelect
Single-Line Configuration Guide (
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. Please refer to the MetroSelect Single-Line Configuration
Guide or MetroSet2's help files for instructions on changing the
scanner's factory default configuration. The scanner and host system
must use the same communication protocols.
See caution on page 6.
S T
CANNER O

Low Speed (-38)

T H S
HE OST YSTEM
00-02544).
MLPN
Figure 10.
11