TP-Link TL-WN7200ND User Manual page 21

TL-WN7200N
Note:
To build a successful connection by QSS, you should also do the corresponding configuration of
the Access Point for QSS or WPS function
I. PBC Method
If your Access Point is equipped with a push-button for Wi-Fi Protected Setup, you can connect
the adapter to the Access Point by Push QSS Button method.
Step 1 Click the QSS button (marked by the red circle) on the screen as Figure 3-9.
Or: Press and hold the QSS button on the adapter (shown on the following figure) for 2 or 3
seconds.
Step 2 Press the QSS button on your Access Point device to build the connection.
II. PIN Method
If your Access Point supports Wi-Fi Protected Setup and the PIN method, you can add the
adapter to the network by the following two ways:
150Mbps High Power Wireless USB Adapter User Guide
meanwhile.
Figure 3-9 QSS- QSS BUTTON mode
- 16 -