Creating A Protocol Filter - Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual

Filter Setup

Creating a Protocol Filter

Step 1
Step 2
Cisco Aironet 1200 Series Access Point Software Configuration Guide
3-10
Figure 3-4 Main Body for Protocol Filters Pages
Follow this link path to reach the Ethernet Protocol Filters page:
On the Summary Status page, click Setup.
1.
On the Setup page, click Filters in the Ethernet row under Network Ports.
2.
Follow this link path to reach the AP Radio Protocol Filters page:
On the Summary Status page, click Setup.
1.
On the Setup page, click Filters in the AP Radio row under Network Ports.
2.
The left side of the Protocol Filters page contains links to the Ethertype Filters,
the IP Protocol Filters, and the IP Port Filters pages. These links also appear on
the main Setup page under Associations. Use the Protocol Filters pages to assign
protocols to a filter set.
the protocols available on each page.
Follow these steps to create a protocol filter:
Follow the link path to the Ethernet or AP Radio Protocol Filters page.
Click Ethertype, IP Protocol, or IP Port to display the Filters page that contains
the protocols you want to filter.
Table B-1, Table B-2, and
Figure 3-5 shows the Filters page.
Chapter 3 Configuration
Table B-3 in Appendix B list
OL-2159-03