Pptp - D-Link DIR-652 User Manual

Section 3 - Configuration
Choose PPTP (Point-to-Point-Tunneling Protocol) if your ISP uses a PPTP connection. Your ISP will provide you with a username and
password. This option is typically used for DSL services.
Address Mode:
Select Static if your ISP assigned you the IP address, subnet
mask, gateway, and DNS server addresses. In most cases, select
Dynamic.
PPTP IP Address:
Enter the IP address (Static PPTP only).
PPTP Subnet
Enter the Primary and Secondary DNS Server Addresses (Static
Mask:
PPTP only).
PPTP Gateway:
Enter the Gateway IP Address provided by your ISP.
PPTP Server IP: Enter the Server IP provided by your ISP (optional).
Enter your PPTP username.
Username:
Password: Enter your PPTP password and then retype the password in the
next box.
Select either Always on, On demand, or Manual.
Reconnect Mode:
Enter a maximum idle time during which the Internet connection is
Maximum Idle
Time: maintained during inactivity. To disable this feature, enable Auto-
reconnect.
DNS Servers: The DNS server information will be supplied by your ISP (Internet
Service Provider.)
MTU: Maximum Transmission Unit - you may need to change the MTU
for optimal performance with your specific ISP. 1400 is the default MTU.
D-Link DIR-652 User Manual
Internet Setup

PPTP

16