CHASSIS:
BODY:
SEAT:
MOWER DECK:
BLADE DRIVE:
DRIVE SYSTEM:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
NOTE:
Page 10
SPECIFICATIONS
Model ZTR 5020
11 GA - rectangular tube
Two piece - made of rotational molded polyethylene. Front body contains
access panels for battery service and engine to mower deck belt removal. Rear
body tilts up to allow service on the entire drive system.
Designed for operator comfort by use of high density closed cell foam padded
back rest and arm rests, upholstered with Cordura™ water-repellent fabric.
Seat is adjustable fore and aft.
3 Decks are available. 42" & 60" are made of stamped steel. 50" is made of
1 1 GA fabricated welded construction with external reinforcement ribs 3
blades combine for either a 42", 50", or 60" cut width Cut height
approximately 1 .5" to 4.5" via 8 position lift handle
Electric clutch
Each rear wheel is independently driven by a HydroGear BDU-10L Series 70
hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
enclosed HydroGear gearbox.
20HP Briggs & Stratton Intek, overhead valves, replaceable oil filter, full
pressure lube system, dual element air cleaner, integral fuel pump.
Electric by key switch operation with safety interlocks on parking brake and
blade drive clutch.
Front
11 X 4 X 5 smooth profile
Rear
20 X 1 0.5 X 8 Multi Trac
Front
16-21 Ibs.
Rear
8- 14 Ibs.
Fuel - 4.8 gallons total (dual tanks)
Hydrostat oil tank - 3 quart with in-line 10 micron filter
Hydrostat oil recommendation, refer to page 37
Engine - 2 qts. SAE 30 (with filter)
Width
54"(42" Deck), 60"(50" Deck), 73"(60"Deck)
Height
45"
Length
72"
Weight
630 lbs.(42" Deck), 668 Ibs. (50" Deck), 685 Ibs. (60" Deck)
Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
,