Install Firmware - Panasonic DMR-E85HS Firmware Instructions

3

Install Firmware

CAUTION: Do not turn the DVD Recorder OFF or press any buttons on the DVD
Recorder while the firmware update is in progress.
1) Power the DVD Recorder on.
2) Press the [OPEN/CLOSE] button to
3) Place the CD-R with the firmware update into the disc tray with the label side facing up.
4) Press the [OPEN/CLOSE] button to
NOTE: If the firmware version in the unit is the same or higher than the firmware
CD, UNSUPPORT may be displayed on the front panel. In this case, an update is
unnecessary. Please remove the disc.
NOTE: If the firmware update will be installed,
the DVD Recorder will power off, and then power back on.
NOTES:
• Several messages will be displayed on the front panel during the firmware
update.
• When the firmware update is complete, the disc tray will automatically OPEN.
5) Remove the CD-R with the firmware update from the disc tray.
6) Without closing the disc tray, press the [POWER] button on the DVD Recorder to power
the unit off. The disc tray will
7) Unplug the power cord for at least 30 seconds, and then plug the power cord back in.
8) Press the [POWER] button on the DVD Recorder to power the unit on. (The unit will
display HELLO and then begin the
NOTE: If the unit does not begin the
recommended to initiate the
• Tune the DVD Recorder to a channel.
• Simultaneously press the [CHANNEL UP] and [CHANNEL DOWN] buttons on the
front of the DVD Recorder for approximately 10 – 15 seconds (until the unit powers
off).
• When the DVD Recorder is powered back on, the
be displayed.
9) Follow the on-screen prompts to complete the
DMR-E85 DVD Recorder Firmware Installation Instructions
OPEN the disc tray.
CLOSE the disc tray.
CLOSE automatically, display
FIRST TIME SETUP.)
FIRST TIME SETUP
FIRST TIME SETUP.
FIRST TIME
Page 6 of 6
BYE will display on the front panel,
BYE, and then power off.
automatically, it is
FIRST TIME SETUP
SETUP.
screen should