Page 1
INSTRUCTION MANUAL WARRANTY Thunder Tiger Corporation guarantees this model kit to be free from defects in both material and workmanship. The total monetary value under warranty will in no case exceed the cost of the original kit purchased. This warranty does not cover any components damaged by use or modification.
INTRODUCTION Thank you for your purchase of this Thunder Tiger product. You should enjoy many hours of fun and excitement from this advanced R/C model. Thunder Tiger strives to bring you the highest level of quality and service we can provide. We race and test our cars around the world to bring you state-of-the-art products.
Pull on the zip-tie while keeping the small lever pressed. Pull the zip-tie out completely. CHARGING THE GLOW PLUG IGNITER Thunder Tiger Optional Part #2165, 1300MAH Glow Starter w/220V Charger. Thunder Tiger Optional Part #2166, 1300MAH Glow Starter w/110V Charger.
GLUING TIRES / WHEELS To glue the tires, peel back the tire from wheel. Place a drop of CA glue into the opening, rotate to the next area without glue, place another drop, and keep doing this until tire and wheels are glued. Only do this step to one side of tire/wheel at a time. After the CA glue has been applied, place a rubber band on the side the tire/wheel with glue until the glue has completely dried.
RADIO OPERATION When turning radio on, first turn on the transmitter. Then, turn on the receiver. When turning off, first turn the receiver off, then the transmitter off. To reverse the functions of servos, use the small, white servo reverse switches located on side of the pistol transmitter (or the inset servo reverse switches located at the bottom of the stick transmitter).
ADJUSTING THROTTLE / BRAKE LINKAGE To set the throttle/ brake linkage, first the radio should be on and neutral; thus, the servo is at neutral position. With the servo at neutral, loosen the brake linkage collar and move it to a point where the brake levers still have 2mm of space before brakes are engaged.
(replace with new one). After checking, reinstall the glow plug. The glow plug used for this engine can be: Thunder Tiger 9281, McCoy #9 / #59, Novarossi C4S / C5S / C6S,OS #8 / #A3 / #A5, and Picco P6S / P7S.
STARTING THE ENGINE Turn on the radio (transmitter first, then receiver) Clip the glow plug igniter onto engine's glow plug. Pull on the engine starter, release, repeat until the engine starts. Throttle maybe required to be opened momentarily, step 9a (release back to neutral immediately after it starts). Remove the glow plug igniter from engine after engine has started and warmed up.
Also, check your radio for proper operation before operating a mode. 6. Improper operations may cause personal and/or property damage. Thunder Tiger and its distributor have no control over damage resulting from shipping, improper construction, or improper usage.
Page 10
SET-UP FRONT 3000 MORE STEERING 5000 STANDARD 10000 LESS STEERING SLOWER STANDARD STEERING QUICKER 350 400 450 STEERING STANDARD STANDARD CAMBER -2˚ STIFFER SUSPENSION, More +, more steering LESS BUMPY TRACK. More -, less steering CASTER 18˚ More +, less steering STANDARD FOR FLAT TRACKS More -, more steering...
TROUBLESHOOTING If you have trouble starting or keeping your EB4-S2 PRO running, here's a quick checklist of what to look for first. Description Problem Solution Engine will not Out of fuel ..............Fill fuel tank start Contaminated fuel ............ Replace fuel Glow plug igniter not charged ........
Page 12
The Thunder Tiger EK-4 Simply the biggest, baddest RC truck ever to roll off the production line. The fire breathing EK-4 eats all other trucks for breakfast! lunch and dinner! With three times the output of the closest competition the EK- 4's oversized tyres and seven shock absorbers gives the PRO- 70 engine the power to effortlessly charge over ANY terrain.