Table of Contents
Advertisement
– Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output (I/O) ports. You can
configure the serial ports; configure remote console redirection; enable or disable integrated Ethernet
controllers, the SAS/SATA controller, SATA optical drive channels, and PCI slots; and view the
system Ethernet MAC addresses. If you disable a device, it cannot be configured, and the operating
system will not be able to detect it (this is equivalent to disconnecting the device).
– Power
Select this choice to view or change power capping to control consumption, processors, and
performance states.
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does not support UEFI video
output standards.
- Rehook INT
Select this choice to enable or disable devices from taking control of the boot process. The default
is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass storage devices that are
non-UEFI compliant.
– Integrated Management Module
Select this choice to view or change the settings for the integrated management module.
- POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
- Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt (NMI) occurs.
Disabled is the default.
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on IMM.
- Network Configuration
Select this choice to view the system management network interface port, the IMM MAC address,
the current IMM IP address, and the host name; define the static IMM IP address, subnet mask,
and gateway address; specify whether to use the static IP address or have DHCP assign the IMM
IP address; save the network changes; and reset the IMM.
- Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
- Reset IMM
Select this choice to reset IMM.
– System Security
Select this choice to view or configure Trusted Platform Module (TPM) support.
– Adapters and UEFI Drivers
Select this choice to view information about the UEFI 1.10 and UEFI 2.0 compliant controllers and
drivers installed in the server.
– Network
Select this choice to view or configure the network device options, such as iSCSI, PXE, and network
devices.
Chapter 7. Configuring the server
91
Advertisement
Table of Contents
