Energy Saving Mode - Canon CanoScan D1230UF User Manual

chapter 4
What is on the
Screen?
Top Page
Glossary
Contents
Index
High-speed Scan Mode
This function is available when Image Source is set to [Platen]. When a
check mark is placed beside this option, scanning can be accomplished
faster because the lamp output data (auto color adjustment data) from
the first pass is used for subsequent passes. The default setting is Off for
this function.
It may take some time to acquire the lamp output data
on the first scan after the high speed scanning mode is
selected. Similarly, the first scan after ScanGear CS-U is
Note
started make take some time even when the high
speed scanning mode is selected.

Energy Saving Mode

Click this check box to put the scanner in the energy save mode. If the
scanner remains idle for the amount time specified in the Shut Off Lamp
Time box, the scanner lamp switches off. As soon as you start another
scanning job, the lamp switches on again.
Shut Off Lamp Time
This option is enabled when the Energy Saving Mode is switched on. This
sets the amount of scanner idle time to elapse until the scanner
automatically enters the Energy Saving Mode. Select a value (default: 12
min.) in increments of 4 minutes within the range 4 to 56 minutes.
(Actual time may slightly differ from the setting values.)
60