Operating Instructions; Technical Specifications; Troubleshooting - Cambridge Audio TOPAZ AM10 User Manual

Operating instructions

After making any connections to your unit, activate the Topaz AM10 by
pressing the On/Off button on the front of the unit.
Press the Source button on the front of the unit corresponding to your
desired source. Alternatively, you may use the appropriate button on the
remote control.
FM / AM FM / AM CD CD BD / DVD BD / DVD
Use either the Volume Up/Down buttons on the remote control, or the
Volume control on the front of your unit system to change the volume
level. The newly selected level will be indicated briefly on the front display.
The volume is displayed in minus dB where 0dB is the highest level.
A progressively larger negative number indicates the volume is being
reduced.
Adjustments to the bass, treble and balance can be made as follows:
1. To enter the audio menu. Press either the Menu button on the front of
the unit or on the remote control.
2. Step through the available settings by pressing the Menu button. The
settings available are in order Bass, Treble and Balance.
3. When you wish to make an adjustment for bass, treble or balance,
simply rotate the Volume control or use the Volume control buttons on
the remote control.
4. To exit, wait for five seconds, until the unit returns to normal mode.
MP3 / Aux Phono Phono Speaker A / B Speaker A / B

Technical specifications

35 watts (into 8Ω)
<0.01% @ 1kHz, 80% of rated power
<0.15% 20Hz - 20kHz, 80% of rated power
5Hz - 50kHz
>82dB (unweighted)
47k ohms
>50
260W
Shelving, ultimate boost/cut
+/- 10dB @ 100Hz and 10kHz
76 x 430 x 340mm
(3.0 x 16.9 x 13.4")
5.6kg (12.3lbs)

Troubleshooting

Ensure the AC power cord is connected securely.
Ensure the plug is fully inserted into the wall socket and is switched on.
Check fuse in the mains plug or adaptor.
Check the power is on at the front of the unit.
Check the correct input is selected.
Check that the speakers are connected correctly.
Check the unit is not in mute mode.
Check speaker connections.
Ensure that all cable connections are secure, particularly ground/shield
connections for turntables.
Move the unit away from other electrical equipment that is likely to cause
interference.
Ensure that all cable connections are secure, particularly ground/shield
connections for turntables.
Check that the batteries have not expired.
Ensure that nothing is blocking the remote sensor.
In the event that the above solutions do not remedy your problem, please
consult our frequently asked questions (FAQ) section on our website:
For all servicing, in or out of warranty, please contact your dealer.
AM10
9